Français
English
Load cells
- What are the nominal supply voltages according to the different types of outputs offered by Sensy ?
- Can I put 2 dynamometric axes on a load limiter ?
- What is the maximum cable length available for an Exi certified sensor?
- What is the required power supply for a sensor with integrated amplifier that provides a 4-20 mA (2-wires) signal?
- Can a load pin be used in both directions ?
- What different types of rope reeving systems are used for lifting equipment?
- What is the maximum length of measurement cables ?
- Why is it necessary to connect SENSY electronics and sensors to protective earth ?
- What is the fatigue resistance of SENSY load cells and torque sensors?
Electronics
- I have a load limiter composed of a load cell and a BRIDGE-BOY. When there is no load on hoisting device, the BRIDGE-BOY triggers unexpectedly.
- How to change the sensitivity range of the bridge-boy ?
- What is the accuracy of the INDI-PAXS ?
- Is it allowed to connect multiple sensors in parallel to the same overload protection electronics?
- How to tare a DIS P-Fx-yz display using an external contact.
- What is the accuracy of an overload protection system for EOT crane using load pins.
- Configuration of the RS232 output of INDI-5250 or INDI-00
- How to define different trigger thresholds from a button on our digital load limiters ?
- Configuration of the pax family products in order to recover the value displayed on my PC or my PLC.
- How to apply a calibration resistor (Rcal) on a sensor already delivered ?
- What is the measurement and refresh rate of a display of the PAX series and its analog output (CARD-CDL10) ?